What is the Diference between DYN 11 and DYN 5 .How to
change the Vector group from DYN 11 to DYN 5.
Answers were Sorted based on User's Feedback
Answer / rushi n. gajjar
dyn5 test of transformer in which some condition like U,V AND W. primary and sec. side we check
1U2W=1U2V;
1W2V<1W2W
1V2V=1V2W we found all this condition in dyn5 test.
dyn11 is vector diagram of 3 phase xmer phase difference 60 degree between R ND Y same way....
Is This Answer Correct ? | 21 Yes | 8 No |
Answer / kobena wiredu
DYn means a delta-star connected transformer in which the primary is delta connected and the secondary is star connected. The number that follows tells us the position of the Red phase of secondary relative to the primary using the clock (primary Red phase at 12oclock).So Dyn11 means secondary is on the 11 oclock line and hence leads the primary by 30deg since anticlockwise is the convention.To convert from one DYn to the other you need to change both primary and secondary connections. You do this by drawing vector diagrams. By using vector diagrams i find that converting from Dyn11 to Dyn5 means: Change ABC to ACB and change abc to cba.
Is This Answer Correct ? | 9 Yes | 0 No |
Answer / hemant dehariya
In DYN 11 & DYN 5 is DYN 11 is HV voltage is lead from LV by angle of 30 degree and in DYN 5 HV voltage leg fron LV voltage by 150 degree.we can change vector group from DYN 11 to DYN 5 by change primary winding connection of transformer.
Is This Answer Correct ? | 21 Yes | 18 No |
how the 3phase induction motor is running in 2phase supply with help of capacitor?
Can we connect two CT'S to one energymeter?
What is the difference between Isolator & Load Break Switch?
Why we are use dol starter up to 10 hp
could i arrange a faulty and healthey battery bank togather in parallel , if your ans is not then why?
can we run three phase motor by single phase? and what happens if we do this
What may be happen if neutral and earth is shorted in a substation
Why do we use center tap transformer that used with portable tools
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
WHAT IS THE USE OF STARTER AND CHOKE IN TUBE LIGHT?
Why Ferranti effect not occurs at full load?
how we calculate electricity unit ( meter unit.. for knowing how many charges) from on motor load.?